Fault
Heavy foam build-up
High spin speed not
reached.
The spin programme does
not start.
Noise
Fault
Rushing, hissing noise.
Loud noises during the spin
cycle.
Cause
Detergent dosage is too
high.
A low spin speed is selected.
Unbalance load detection
system is using a reduced
spin speed to eliminate an
unbalance.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Cause
Water is flushed under pres-
sure into the detergent
drawer.
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Troubleshooting en
Troubleshooting
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the left-hand compartment (not
for outdoor clothing, sportswear or
items stuffed with down).
Reduce the amount of detergent for
▶
the next washing cycle with the
same load.
The next time you run a wash cycle,
▶
set a higher spin speed.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Στύψιμο programme.
▶
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Στύψιμο programme.
▶
Troubleshooting
Not a fault – normal operating
▶
noise.
Aligning the appliance
▶
Secure the appliance feet. Aligning
▶
the appliance
53