B) Registering The Outdoor Sensor; C) Installing/Removing The Outdoor Sensor - Conrad Electronic ASH888 Operating Instructions Manual

b) Registering the Outdoor Sensor

• After selecting the desired display location of the sensor, switch the
receiving station to receiving mode according to your operating manual.
• Now, carefully press the "A" key on the outdoor sensor (see figure for
position) by means of a pointed object (e.g. toothpick). Thus, the sensor
is registered to the receiving station.
• Now, close the battery compartment.
• Put the protective cap onto the sensor as far as it will go.

c) Installing/Removing the Outdoor Sensor

The outdoor sensor can be attached easily to a vertical surface by means
of the enclosed mounting support.
Attention!
Choose a protected place of installation which is not directly
exposed to rain or snow, dust or direct sunlight! For outdoor
installation, e.g. a position underneath the roof overhang
might be appropriate.
The mounting support can be screwed onto a vertical surface (mounting
hole "B") by means of a suitable screw as shown in the figure below.
Please make sure that the "A" groove of the housing points to the left as
shown in the figure.
28
A
B