Rear Panel - PHENYX PRO PRX Series Owner's Manual

① Effect Program List
This is the list of built-in effects programs. For details about these programs, see the "Effect Programs" on page 15.
② LCD Display
Indicates the effect program number selected with the [PROGRAM] knob. The corresponding information flashes
during selection; however, if several seconds pass without a selection being made, the program returns to the last
number selected.
③ [PROGRAM] Knob
Turn the knob to select the desired effects, and then press the knob to enable it.
④ [PARAMETER] Knob
Adjust the parameter (depth, speed, etc.) for the selected effect.
⑤ [EFF VOL] Knob
This knob adjusts the level of the effect sent from the built-in effects to all channels (also include [USB 1.0] section
when turned on), and MAIN OUT buses.
① POWER SWITCH
POWER DC INPUT
② DC INPUT
① [-/o] POWER Switch
Press the switch to the "-" position to turn on the power. Press the switch to the "o" position to turn off the power.
② DC Input
Connect the power cord to the DC input jack.
®

Rear panel

CAUTION:
CAUTION
REPLACE FUSE
WITH SAME TYPE FUSE AND RATING
RISK OF ELECTRIC SHOCK!
DO NOT OPEN!
ATTENTION:
ATTENTION
UTILISER
UN FUSIBLE DE RECHANGE DE
RISQUE DE CHOC ELECTRIGUEI
MEME TYPE ET CALIBRE
NE PAS OUVRIR!
12
Troubleshooting
1 - When there is no sound in the stereo output:
① Check if the mixer connects microphones, external devices, and the speaker.
② Check if you have turned on all charged devices mentioned above.
③ Check if you have adjusted GAIN & VOL in relevant channels and MAIN
LEVEL to proper levels.
2 - When the sound is small, distorted, or noisy:
① Check if the peak indicator flashes.
Yes: turn down GAIN in relevant channels, or turn on PAD.
No: adjust VOL in relevant channels and MAIN LEVEL to proper levels.
② Adjust 3-Band EQ (HIGH, MID & LOW) to propel levels to minimize noise.
3 - When no effect is applied:
① Check if you have pressed PROGRAM to confirm the program.
② Check if you have adjusted EFF VOL and PARAMETER to proper levels.
Specification
Effect Programs
Number Program
HALL 1
1
2 HALL 2
3 ROOM 1
4 ROOM 2
REVERB+DELAY
5
DELAY 125MS
6
DELAY 175MS
7
DELAY 225MS
8
DELAY 285MS
9
DELAY 560MS
10
DELAY 860MS
11
DELAY 1000MS
12
DELAY 1400MS
13
14 PING-PONG DELAY 800MA
15 PING-PONG DELAY 1000MA
16 PING-PONG DELAY 1400MA
®
Description
Imitate different reverbration level in large
space like a concert hall
Imitate different reverbration level in a
small space like a room
Reverb and delay together to strengthen reverbration
Different delay time
Delay respectively twists in the left and
right in different time.
13