Front Panel; Input Channel Section - PHENYX PRO PRX Series Owner's Manual

Front panel

MIC/LINE IN MIC/LINE IN MIC/LINE IN MIC/LINE IN
①
②
+48V +48V +48V
PHANTOM PHANTOM PHANTOM PHANTOM
GAIN GAIN GAIN GAIN
30 30 30 30
③
PAD PAD PAD
-20dB -20dB -20dB
PEAK PEAK PEAK
5 60dB 5 60dB 5 60dB 5 60dB
HIGH HIGH HIGH HIGH
-15 +15 -15 +15 -15 +15 -15
MID MID MID MID
④
-15 +15 -15 +15 -15 +15 -15
LOW LOW LOW LOW
-15 +15 -15 +15 -15 +15 -15
AUX1
AUX1 AUX1 AUX1
⑤
MON MON MON
MON
0 +10 0 +10 0 +10 0
AUX2 AUX2 AUX2
⑥ AUX2
FX FX
FX FX
0 +10 0 +10 0 +10 0
2 3
VOL VOL
⑦ VOL VOL
0 +10 0 +10 0 +10 0

1 - Input Channel Section

① Mono Input Jacks
[MIC/LINE]: Accepts both XLR and TRS connectors.
Connect microphones and/or instruments you intend to use.
② [PHANTOM +48V] Switch And Indicator
This switch toggles phantom power on and off. Turn this switch on (
supply DC+48V to mono input jacks.
*NOTE:
-Please leave this switch off ( ) if you do not need phantom power.
-Each mono XLR balanced channel has a separate phantom power control.
③ [GAIN] Knobs
For adjusting the gain of the input signal.
*NOTE:
-This control should always be turned fully counterclockwise when you
disconnect a signal source to one of the inputs.
®
⑫ ⑪
⑧ ⑩
MAIN OUT PHONE USB
L R
USB Bluetooth
TO PC
⑬
L(MONO) R 1 2
P/P PREV NEXT MODE
+48V
MON FX
5/6 5/6
⑨
AUX SEND DIGITAL AUDIO PLAYER
USB
HIGH
10
PRX-600
PAD
-20dB ⑭
PEAK -15 +15
7·BANO STEREO GRAPHIC EGUALIZER
MID
+12 +12
+6 +6
+15 -15 +15
0 0
LOW -6 -6
-12 -12
+15 -15 +15 63 160 400 1K 2.5K 6.3K 16K
5/6
VOL
⑱
+15 -15 +15
AUX1 SEND
16
L R
DSP CUP
⑰
6
32
0
+10 0 +10
40 6
AUX2 SEND 24
FX
PROGRAM PAPAMETER FX TO AUX1
+10 0 +10
MIN MAX 0 +10
4
EFF VOL
PHONE LEFT RIGHT
MAIN
+10 0 +10 0 +10 0 +10 0 +10
⑮ ⑯
MIC/LINE IN
) to
+48V
PHANTOM
GAIN
30
PEAK
5
60dB
8
④ Equalizer ([HIGH]/[MID]/[LOW])
The equalizer shapes the high, mid, and low audio frequencies. Turning the knob to the
right amplifies (boosts) the corresponding frequency band, while turning it to the left
attenuates (cuts) the band. Setting the knob to the middle "▼" position produces a flat
response in the corresponding band.
⑤ [AUX1 MON] Knobs
The levels of each signal of the MON buses from each channel can be adjusted
independently. The [AUX1 MON] knobs indicate the level of each channel for
MON jack. Adjust the knobs so that they are near or at the "▼" (normal) position.
⑥ [AUX2 FX] Knobs
The levels of each signal of the FX buses form each channel can be adjusted independently.
The [AUX2 FX] knobs indicate the level of each channel for FX jack. Adjust the knobs so
"▼"
that they are near or at the (normal) position.
⑦ [VOL] Knobs
Adjust the level of the channel signal.
*NOTE: To minimize noise, set the knob for any unused channels counterclockwise to the
minimum.
⑧ Mono/Stereo Input Jacks
[L(MONO), R]: Unbalanced phone type line stereo input jacks. [L/MONO]: Accepts mono
input from the left input.
⑨ [LINE] And [USB] Switch
Switches the audio source between LINE input and USB input.Control the sound from
LINE inputs by leaving this switch off ( ) , and control the sound from USB by turning it on ( ).
*NOTE: [LINE] inputs and [USB 1.0] input CANNOT be adjusted simultaneously.
®
HIGH
-15 +15
MID
-15 +15
LOW
-15 +15
3 Band
AUX1
MON
0 +10
AUX2
FX
0 +10
VOL
0 +10
L(MONO)
5/6
5/6
USB
9