Korg drumlogue Owner's Manual page 28

SNAP.LV (SNAPPY LEVEL)
Adjusts the snappy volume of the snare drum.
CUTOFF
Adjusts the cutoff frequency of the filter.
You can select the low-pass filter, no filter (THRU), or the high-pass filter.
RESON (CUTOFF RESONANCE) [0.0%...100.0%]
Adjusts the cutoff resonance of the filter.
If you increase the value, the filter oscillates, which may cause the sound to
continue.
MIX/ROUTE
PAN
Adjusts the pan pot (left and right stereo localization).
SPREAD
Adjusts the spread of sound (stereo feeling).
DELAY
Adjusts the feed amount of the delay effect.
REVERB
Adjusts the feed amount of the reverb effect.
MASTER
Sets the master effect to On or Bypass.
SIDECH (SIDECHAIN)
Adjusts the feed amount of the SIDECHAIN pass.
LT, HT (Low tom, High tom)
Control knob
LT (HT) DECAY
Adjusts the sounding length of the low-tom or high-tom drumhead.
The greater the value, the longer the sound.
LT (HT) TUNE
Adjusts the pitch of the low tom or high tom. The greater the value, the higher the sound.
LT (HT) DETUNE
Adjusts the tuning deviation between the two drumheads for low tom or high tom.
[0.0%...100.0%]
[L0.0%...L99.5%, THRU, H0.5%...H100.0%]
[L100%...L1%, C, R1%...R100%]
[<100%...<1%, 0, >1%...>100%]
[0.0%...100.0%]
[0.0%...100.0%]
[ON, BYPASS]
[0.0%...100.0%]
[0...1023]
[0...1023]
[0...1023]
28