Common Operations; Turning On And Off The Power; Setting The Clock; Setting The Am Tuner Interval Spacing - JVC SP-MXJ570VUS Instructions Manual

Common Operations

Turning On and Off the Power

To turn on the unit, press
STANDBY lamp goes off.
The Powered Rolling Panel opens automatically.
To turn off the unit (on standby), press
again so that the STANDBY lamp lights up
The Powered Rolling Panel also closes.
A little power is always consumed even while the unit is on
standby.
To switch off the unit completely, unplug the AC power cord
from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "0:00" right away, while the tuner preset
stations (see page 12) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the built-in
clock this unit.
On the unit ONLY:
1
Press PANEL OPEN/CLOSE.
The unit is turned on and the Powered Rolling
Panel opens automatically.
2
Press CLOCK/TIMER.
The hour digits start flashing on the display.
3
Press 4 or ¢ to adjust the
hour, then press SET.
• If you want to correct the hour after
pressing SET, press CANCEL. The hour
digits start flashing again.
4
Press 4 or ¢ to adjust the
minute, then press SET.
so that the
– 9 –
To check the clock time
Press DISPLAY while playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
DAILY ON TIME
Clock
Canceled
setting
(The hour digits start flashing.)
If there is a power failure
The clock loses the setting and is reset to "0:00." You need to set the
clock again.

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
On the unit ONLY:
You can only change the AM tuner interval spacing while
tuning into an AM station.
while holding down 7
Press
• Each time you press the button, the AM tuner interval
spacing alternates between 9 kHz and 10 kHz.

Selecting the Sources

To listen to the FM/AM broadcasts, press FM/AM. (See
page 12.)
To play back CDs, press CD £¥8. (See pages 13 – 19.)
To play back tapes, press TAPE 2 3. (See page 20.)
To select the external equipment as the source, press AUX.
SELECT
When you press the play button for a particular source (FM/
AM, CD £¥8, AUX, and TAPE 2 3), the unit turns on, and
the Powered Rolling Panel opens automatically (and the unit
starts playing the source if it is ready — COMPU PLAY
CONTROL).
REC
ON TIME
.