JVC DT-V20L3GZ Instructions Manual page 19

Operation guide
Shows the buttons for each
operation.
• The menu automatically disappears in about 30 seconds after the previous operation.
• Some items may not appear on the menu depending on the input or the input signal.
• The items controlled by the MAKE system do not appear on the menu.
NOTE
Setting of "CHARACTER SET."
Assign a name for each video source.
1
Change the input to one that you want to assign a video source name for.
2
Select "CHARACTER SET."
3
Press buttons to select the first character.
• Each time you press button, the character changes as follows. Press
Space
4
Press button to move the arrow to the next space.
• The characters entered before moving the arrow are memorized.
5
Repeat steps 3 and 4 (10 characters at maximum).
6
Press MENU button to store the name.
REMOTE SETTING
Settings for the external control
Item
SERIAL TYPE
PARALLEL TYPE
PIN1
PIN2
PIN3
PIN4
PIN5
INFORMATION
Settings for the information display of the monitor
Item
POSITION
SOURCE ID
CHARACTER
SET.*
1
STATUS DISPLAY
TIME CODE
CRC ERROR
SUB HOUR METER Display the hours of use (unit: hour). You can reset this item.
MODEL
VERSION
HOUR METER
button to reverse the order.
* 1 Memorized for each input.
* 2 Ancillary time code
(☞ "External Control" on pages 21 to 23)
To do
Select the input terminal used for external control by
serial communication.
Select the external control method for the MAKE/
TRIGGER terminal.
Assign the control functions to the pins of the MAKE/
TRIGGER terminal.
• Assign a function to each pin terminal by selecting
"SET" in "PARALLEL TYPE" mentioned above.
(The functions are assigned for "PIN6" – "PIN8"
and you cannot change the assignment of these
functions.)
To do
Select the position to show the information display (☞ "On the
Information Display" on page 7).
Select whether the name assigned in "CHARACTER SET." is
displayed on the screen (☞ "On the Information Display" on page 7).
• When "AUTO" is selected, the display color synchronizes with the
color of the tally lamp while the tally lamp is lit.
Assign a name to each video source as you like (10 characters at
maximum). You can also enter a name using the RS-232C system.
Select whether the status of the current input and the setting of
MUTING are displayed on the screen (☞ "On the Status Display" on
page 7).
Select the type of the TIME CODE display.
Select whether the CRC error indication for the input HD SDI signal is
displayed on the screen (☞ "On the Information Display" on page 7).
Display the model name of the monitor.
Display the version of the monitor.
Display the total hours of use (unit: hour). This item is used for maintenance of the
monitor. You cannot reset this item.
Setting value
RS232C, RS485
MAKE, TRIGGER, SET
☞ "Functions controlled by the
MAKE/TRIGGER system" on
page 22
Setting value
UPPER, LOWER
OFF, ON, AUTO
☞ "NOTE"
AUTO, OFF, ON
VITC* 2 , LTC* 2 ,
D-VITC
ON, OFF
19