DeWalt DW33 Instruction Manual page 9

ASSEMBLY, cont'd
Attaching the Shift Lever
1. Remove the screw (a) and the lock nut (b) that secures the shift lever to the shift lever
plate. See Figure 5.
2. Remove the remaining screw (c) and nut (d) from the lower shift lever plate. See
Figure 5.
CONTROLS & OPERATION, cont'd
Deck Height
Lever
Figure 5
Fuel Tank Cap
3. Position the upper shift lever into a vertical position aligning the holes in the lever with
the holes in the shift plate. See Figure 6.
4. Secure the lever to the plate using the two screws (a) and two nuts (b) removed in
Steps 1 and 2. See Figure 6 inset.
Checking Tire Pressure
WARNING: Under any circumstance do not exceed manufacturer's
recommended psi. Equal tire pressure should be maintained at all times. Refer
to sidewall of tire for recommended pressure.
The rear tires on your unit may be over-inflated for shipping purposes. Reduce the tire
pressure before operating the mower. Refer to the tire side wall for tire manufacturer's
recommended psi and deflate (or inflate) the tires as necessary.
Throttle Control
Gear Shift Lever
Figure 7
Figure 6
Blade Control
Ignition Switch
LCD Service Minder and Hour
Meter†
Drive Control
† If Equipped
ENGLISH
9