Summary of Contents for Nero CYCLONE
- Page 1 ® WMTS536:2022 WMK26723 INS T ALLA TION GUIDE INS T ALLA TION GUIDE Demtech Australia Pty Ltd • 1300 300 090 • www.demtech.com.au • Follow us online @demtech.aus...
-
Page 2: Specifications
For full warranty information and to register substrates and structures constructed/ WMTS536:2022 WMTS536:2022 your product please scan the QR code. installed prior to installation of the NERO® WMK26723 WMK26723 Cyclone are compliant with the Australian **Cyclone Sleeve tested (as a stand-alone... - Page 3 ® NOT USING CYCLONE SLEEVE? Key installation instructions differ when using Cyclone Sleeve**. If you are preparing your Cyclone for use with accessories other than Cyclone Sleeve, such as Nero 100mm Sleeve & Grommet, scan the QR code below to download Cyclone Installation Guide.
-
Page 4: Installation Steps
STEP 2 Prior to concrete slab pour, fix the Cyclone into the drainage riser using a plumbing primer and cement suitable for jointing ABS to PVC (AS3879 compliant). - Page 5 ® GOOD GOOD The Cyclone is both level and flush with the surface of the concrete slab. This is the ideal/targeted final outcome. OKAY OKAY The Cyclone is level but sits below the surface of the concrete slab (maximum 20mm below surface).
- Page 6 Use a deburring tool to clean the rough edges around the opening in the lid. STEP 6 Lift the lid out of the body of the Cyclone. Carefully reach through and apply force around the opening until the lid is free.
- Page 7 (pipe sleeve above and locking ring below) otherwise it will not work. STEP 8 Fix the Cyclone Sleeve into the lid using a plumbing primer and cement suitable for jointing ABS to ABS (AS3879 compliant). Apply plumbing primer and cement to...
- Page 8 Use a router to create a recess around the 270mm opening measuring 12mm wide by 3mm deep. This will allow the Cyclone to sit flush with the surface of the substrate. Demtech Australia Pty Ltd Ver. 1.0 | Rev. AUG 2022...
- Page 9 Apply a continuous bead of sealant within the recess around the opening and install the Cyclone into the substrate. Press firmly around the fixing flange ensuring the Cyclone is sitting flush and level with the substrate. STEP 5 Using eight-gauge stainless steel...
- Page 10 Use a deburring tool to clean the rough edges around the opening in the lid. STEP 9 Lift the lid out of the body of the Cyclone. Carefully reach through and apply force around the opening until the lid is free.
- Page 11 (pipe sleeve above and locking ring below) otherwise it will not work. STEP 11 Fix the Cyclone Sleeve into the lid using a plumbing primer and cement suitable for jointing ABS to ABS (AS3879 compliant). Apply plumbing primer and cement to...
- Page 12 ® WMTS536:2022 WMK26723 INS T ALLA TION GUIDE INS T ALLA TION GUIDE Demtech Australia Pty Ltd • 1300 300 090 • www.demtech.com.au • Follow us online @demtech.aus...