Advertisement
INSTALLATION STEPS
CYCLONE INSTALLATION GUIDE
SUSPENDED SUBFLOOR APPLICATION
STEP 7
Mark where the connection is required on
the lid and drill a pilot hole using a 5.5mm
dril bit in the centre of the marking.
STEP 8
Use a 133mm hole saw to make an
opening in the lid. Take care not to drop
the lid cut-out into the Cyclone.
Use a deburring tool to clean the rough
edges around the opening in the lid.
STEP 9
Lift the lid out of the body of the Cyclone.
Carefully reach through and apply force
around the opening until the lid is free.
Demtech Australia Pty Ltd
10
Ver. 1.0 | Rev. AUG 2022
Advertisement
