Advertisement
ELECTRICAL CONNECTIONS
A
Typical connections
Before connecting:
Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
To external components (see diagram
Antenna terminal
Line out (see diagram
White with black stripe
White
Left speaker (front)
B
Connecting the external amplifier or subwoofer
You can connect an amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Set "L/O MODE" to "REAR"
(See page 13 of the INSTRUCTIONS.)
Set "L/O MODE" to "WOOFER"
(See page 13 of the INSTRUCTIONS.)
C
Connecting the external components
JVC CD changer, Apple iPod, or JVC D. player
Set "CHANGER" for the external input setting (See page 14 of the INSTRUCTIONS.)
•
You can connect these components as illustrated below.
The iPod or D. player can be connected using an interface adapter (not supplied)—KS-PD100 (for iPod) or KS-PD500 (for
D. player)
CD changer jack
1
*
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.
3
*
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
*
4
Remote lead
*
5
Signal cord (not supplied for this unit)
6
*
Connecting cord supplied for your CD changer
*
7
Line Input Adapter KS-U57 (not supplied for this unit)
8
*
AUX Input Adapter KS-U58 (not supplied for this unit)
)
Rear ground terminal
15 A fuse
)
Black
*
2
Yellow
Red
Blue
Blue with white stripe
Orange with white stripe
Gray with black stripe
Right speaker (front)
JVC Amplifier
Rear speakers
JVC Amplifier
Subwoofer
CAUTION:
Before connecting the external components, make
JVC CD changer
sure that the unit is turned off.
or
Apple iPod
iPod is a trademark of Apple Computer, Inc.,
or
registered in the U.S. and other countries.
JVC D. player
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any
(250 mA max.)
Gray
Green with black stripe
or
2
To the remote lead of other equipment (200 mA max.)
To car light control switch
Green
Purple with black stripe
Left speaker (rear)
Y-connector (not supplied for this unit)
Remote lead (blue with white stripe)
To the remote lead of other equipment or automatic antenna if any
Front speakers
Other external component
Set "EXT IN" for the external input setting (See page 14 of the
•
INSTRUCTIONS.)
CD changer jack
3.5 mm stereo mini plug
or
Ignition switch
Fuse block
Purple
Right speaker (rear)
External component
External component
Advertisement
