Pre-Installation; Planning Installation; Tools Required; Hardware Included - Glacier bay SIMARD 15606 Use And Care Manual

Pre-Installation

PLANNING INSTALLATION

To ensure your installation goes smoothly, please read these instructions carefully and review the recommended tools and hardware before
you begin.
To remove the old vanity (if applicable): 1) Turn off the water supply and drain out. 2) Disconnect the supply lines from the faucet.
3) Remove the old vanity top and vanity. If the new vanity is not installed immediately, temporarily stuff a rag into the drain pipes.
Using a level, locate any uneven floor and/or wall areas where your vanity will be installed. Unevenness can cause your vanity to become
misaligned resulting in twisting of the cabinet. Repair any uneven areas by reducing high spots or shimming low spots.

TOOLS REQUIRED

Electric drill
with #2 drill bit
Pliers

HARDWARE INCLUDED

NOTE: Hardware shown to actual size.
Part Description
AA Handle
BB 1 in. screw
Two #8 x 2 in.
screws
Safety
goggles
BB
Quantity
Two wall
anchors: if the
vanity will not
be screwed to
wall studs
Phillips
screwdriver
1
2
3
Please contact 1-855-HD-GLACIER for further assistance.
Level
Silicone
(optional)
AA
HOMEDEPOT.COM/GLACIERBAY