Komos KRYO NOMAD Instruction Manual

Komos KRYO NOMAD Instruction Manual

Advertisement

INSTRUCTION MANUAL
CONTENTS:
PAGE 1...................................Important Safety Information
PAGE 2....................................Controller Quick Start Guide
PAGE 2.........................................Installation Requirements
PAGE 2–3......................................DC Cable Requirements
PAGE 3–6............................................................Dispensing
PAGE 7..........................................Cleaning & Maintenance
PAGE 7......................................................................Fault Codes
WARNING
Read entire manual for important
safety information before using
your KRYO. Failure to follow warnings
could result in injury & void warranty.

IMPORTANT SAFETY INFORMATION

Please read this entire instruction manual for important
safety information prior to the use of your KRYO.
Failure to follow these instructions may result
in injury and/or product damage and will void the product
warranty.
GENERAL PRECAUTIONS:
Avoid external heat sources such as direct sunlight, gas
stoves, or other heat-generating appliances.
Ensure that there is always at least 4" of clearance on each
side of the KRYO to allow adequate airflow. Not allowing
adequate ventilation will reduce performance, increase
power consumption and void warranty.
Only use approved cleaners and sanitizers to clean the
product lines.
Do not set the temperature below 0°C/32°F or you risk
freezing the beverage you are dispensing.
Only use on a flat surface or at a maximum angle of 20
degrees off level.
If using a 12V power inverter to power the NOMAD from
your vehicle's 12V power outlet, never use an inverter rated
to less than 500W power at 100% duty cycle.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KRYO NOMAD and is the answer not in the manual?

Questions and answers

Summary of Contents for Komos KRYO NOMAD

  • Page 1 CONTENTS: PAGE 1........Important Safety Information PAGE 2........Controller Quick Start Guide PAGE 2.........Installation Requirements PAGE 2–3........DC Cable Requirements PAGE 3–6............Dispensing PAGE 7..........Cleaning & Maintenance PAGE 7……………..………….…………………………..Fault Codes INSTRUCTION MANUAL WARNING Read entire manual for important safety information before using your KRYO. Failure to follow warnings could result in injury &...
  • Page 2 TEMP CONTROLLER QUICK START GUIDE • Do not set the temperature below 0°C/32°F or you risk freezing the beverage you are dispensing. 1. Press the Power Button to turn on the unit. the unit back to your programmed target temperature. The default Differential setting is 2°C, but you can adjust 2.
  • Page 3 to produce a clean straight cut. A 7 in 1 spanner tool (D1269) can also be used to remove hosing from the push in fitting. Insert the hose into the groove in the center of the spanner and use the spanner to press in on the collet while pulling on the hose. After your taps are attached and your kegs are connected to your NOMAD you can then hook CO up to your keg and set the pressure based on your desired carbonation level and the ambient temperature according to a carbonation...
  • Page 7 CLEANING AND MAINTENANCE Use a streak free stainless steal cleaner/polish to clean the outside of the NOMAD to keep it looking shiny and new. Only use approved cleaners to clean and sanitize your product lines. APPROVED CLEANERS: • Sodium Percarbonate (CL09) / Oxyclean • PBW (CL25) • Saniclean (CL27) • Star San (CL26) Line Cleaning Always clean between every keg use.

Table of Contents