Connecting The Control Box - Dometic GROUP WAECO PerfectView Accessory Instruction Manual

_RV-SWITCH-SV.book Seite 19 Montag, 24. Oktober 2011 8:34 20
Schaltbox
6

Connecting the control box

6.1 Tools required
To make and test the electrical connection, the following tools are required:
insulating tape
heat shrinking sleeve
diode test lamp (fig. 1 1, page 3) or voltmeter (fig. 1 2, page 3)
crimping tool (fig. 1 4, page 3)
soldering iron (optional) (fig. 1 5, page 3)
solder (optional) (fig. 1 6, page 3)
cable bushing sleeves (optional)
6.2 Testing the control box and components
Before you install and connect the desired components, you should test the system. In
this way you can determine whether the components work together in the way you want.
You thus avoid having to dismantle the components later.
To test the system, proceed as follows:
➤
Lay out the individual devices.
➤
Connect the devices as described in the following chapter, but without securing the
cables .
➤
If necessary, connect the control cables.
➤
Switch the system on.
➤
Check to see whether the components are working together as desired.
✓ If the system is working to your satisfaction, you can secure the devices and cables.
6.3 Connecting the control box
NOTICE!
A
Ensure that all lines are connected correctly. The control line may never be
connected to earth; doing so can damage the device. Make especially sure
to insulate the bare end of the control line when it is not in use and thus not
connected.
If you possess a monitor that may only be used for 12 V and 24-V electrics is
being used, a voltage converter must be installed.
EN
Connecting the control box
19