Advertisement
For use with software, the controller's address must be
changed from 255 to any number between 1 and 254. If you
have more controllers on the communication line, don't
duplicate addresses. Add them one by one on the
communication line, because every controller has address
255 by default. You must change the controller's address
before using any card. If you do not change the address, the
first card you register will become the master card. If you
have used the controller as a standalone controller before
you will use it with software, you need to save your master
card and code because they cannot be replaced, or you can
set the controller to default settings (function 13).
Changing back to standalone controller from access
controller:
Change the controller's address back to 255. If you have not used
the controller as a standalone controller, the first card you register
will become the master card. If you have already used the
controller as a standalone controller, the master card is the same
as before. It is recommended to reset the controller to default
settings (function 13).
Communication
Connect the controller to the computer, with one of the power
supplies, with communication converter, from the Spider family:
Spider W5-USB, Spider W5-NET, Spider W40+NET.
The RS485 communication bus is used between the controllers and
Jantar software. Up to 128 controllers can be lined up into one
communication line. The maximum length of the communication
line is 1000 cable meters. It is recommended that you use an FTP
or S-FTP cable. Only a serial connection of controllers in a single
communication line is allowed. Star (parallel) connection is not
allowed.
All shields of S-FTP cables must be wired together and at one
point connected to the earth. Individual connections to the earth
are not allowed. Do not connect the shield of the cable to the
ground of the controller.
ORDERING CODES
REX [box]-[card]-[software]
Box:
K
Card:
1 – reading frequency 125kHz (cards)
3 – reading frequency 13.56MHz (cards)
Software: 7 – V7, STOP, BLOCKER
Code
Description
REX K-1-7
Standalone or access controller with keypad
in K box, Frequency 125kHz, for V7, STOP,
BLOCKER or CODEKS software
REX K-3-7
Standalone or access controller with keypad
in K box, Frequency 13.56MHz, for V7,
STOP, BLOCKER or CODEKS software
OTHER
Warranty only applies when the controller Rex is used with power
supply or/and communication converter from the Spider family.
Please read through our warranty and disclaimer statements.
Connection scheme and additional support for the use of this
product can be found on:
http://www.jantar.si/forum/en
CONTACT:
Jantar d.o.o.
Kranjska cesta 24
4202 Naklo
SLOVENIA
Black line
REX K-1-7 – Standalone or access controller
web:
www.codeks.eu
mail:
sales@jantar.si
11/2012
www.codeks.eu
Advertisement
