Page 2
Step 1 Order #XXXXX - P10 - Quinton - Backwall Assembly 866.652.2100 Item Qty. Description Steps: Left Leg Assembly NOTE: Assembly may be easiest if assembled face down on floor then lifted upright. Middle Leg Assembly 1) Connect upper curved vertical extrusions [3a,3,6] to leg assemblies [1,2,5]. NOTE: When assembling horizontals they should be Upper Curved Vertical 2) Connect lower and upper horizontal extrusions between vertical assemblies by slightly...
Page 3
Step 2 Order #XXXXX - P10 - Quinton - Backwall Attachments 866.652.2100 Accessary Attachment Light Connection Attach header support to backwall then Attach lights to attach header to support with velcro. backwall where desired and tighten in place. Header Header Monitor Mount Attachment Cubby Attachment Attach back plate to connectors...
Page 4
Step 3 Order #XXXXX - P10 - Workstation Assembly 866.652.2100 Part Number Description Left Leg Assembly Right Leg Assembly Horizontal Extrusion Horiontal Extrusion w/ Door Stopper D (w/ Door Stopper) Knobs face INSIDE of workstation Steps: 1) Connect lower horizontal extrusion [C] between bottom of leg assemblies [A and B] as shown. 2) Insert Laminated infill into grooves of leg assemblies [A and B].
Page 5
Step 4 Order #XXXXX - P10 - Workstation Assembly (Cont’d) 866.652.2100 Part Number Description Steps: Horizontal Extrusion 1) Attach horizontal extrusion [E] between vertical leg assemblies [A and B] as shown below. Horizontal Extrusion 2) Insert Laminated infill into grooves of vertical leg assemblies [A and B]. 3) Attach upper horizontal extrusion [F] between vertical leg assemblies [A and B] atop infill.