Maintenance - Sanyo FWBP506FF Owner's Manual

14.

MAINTENANCE

■ Servicing
• Please refer to relevant topics on ˝TROUBLESHOOTING˝ on page 42 before returning the product.
• If this unit becomes inoperative, do not try to correct the problem by yourself. There are no user-serviceable
parts inside. Eject the disc (if possible), disconnect the USB Memory Stick (if connected to the unit), place
the unit into Standby mode, unplug the AC power plug, and please contact: 1-866-212-0436 or visit :
sanyo-av.com
■ Cleaning the Cabinet
• Wipe the front panel and other exterior surfaces of the unit with a soft cloth.
• Never use a solvent, thinner, benzene or alcohol to clean the unit. Do not spray insecticide liquid near the
unit. Such chemicals may discolor the surface or damage the unit.
■ Cleaning Discs
• When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center to outside. Do not
wipe in a circular motion.
• Do not use solvents such as benzine, thinner, commercially available cleaners, detergent, abrasive cleaning
agents or antistatic spray intended for analog records.
■ Cleaning the Disc Lens
• If this unit still does not perform properly although you refer to the relevant sections and to
˝TROUBLESHOOTING˝ in this user manual, the laser optical pickup unit may be dirty. Consult your dealer or
an Authorized Service Center for inspection and cleaning of the laser optical pickup unit.
■ Disc Handling
• Handle the discs so that fi ngerprints and dust do not adhere to the surfaces of the discs.
• Always store the disc in its protective case when it is not used.
• Note that discs with special shapes (heart-shaped discs, octagonal discs, etc.) cannot be played back on this
unit. Do not attempt to play such discs, as they may damage the unit.
■ IR Signal Check
If the Remote Control does not work properly, you can test IR signal using a Digital camera or cell
phone camera to see if the Remote Control sends out the infrared signal.
1. Turn On the Digital camera or cell phone camera.
2. Point the Digital camera or cell phone camera towards the front of the Remote Control.
• If a pulsating light appears on the Display the Remote Control is sending out an IR signal.
D
Note
• Some Digital Cameras or Cell Phones with Camera(s) may have an IR fi lter(s) and will not Display the IR
signal.
• Remote-control operation on any other Remote Control, such as a universal Remote Control, is not
guaranteed.
EN 47