Table of Contents
Advertisement
Frequently asked questions
Problem
The oven lighting does
not turn on.
There is soiling in the
over after the Self Clean
program.
The oven door cannot
be closed.
The rack and other
accessories make a
noise when being
pushed into or pulled
out of the oven.
88
Possible cause and solution
The halogen bulb needs to be replaced.
Danger of burns!
Make sure the heating elements are turned off and
allowed to cool completely.
The lamp cover may be damaged if it falls.
When removing the cover hold it firmly so that it
does not fall. Place a towel on the oven floor and
open door to avoid damage.
Disconnect the appliance from the power supply.
Loosen the bulb cover with the tool supplied at the
back of the frame.
Do not touch the halogen bulb with bare fingers.
Observe the manufacturer's instructions.
Remove the halogen bulb.
Replace it with a new halogen bulb (Sylvania
66740, 120 V, 40 W, G9, FS1).
Press the bulb cover back into place.
Reconnect the oven to the electrical supply.
The Self Clean program burns off soiling in the oven
and leaves it as ash.
Using a soft sponge, warm water and liquid dish
soap remove the ashes.
If coarse soiling remains, start the Self Clean
program again with a longer duration.
As soon as the inner pane is damaged, a safety
mechanism blocks the oven door. The oven door
cannot be closed and the oven functions (oven modes,
special modes and self clean) cannot be used.
Contact the Miele Service Department.
The heat resistant surface of the shelf runners creates
friction when accessories are taken in and out of the
oven.
To reduce the friction, lubricate the runners with a
few drops of cooking oil applied with a paper
towel. Repeat this process after each Self Clean
program.
Advertisement
Table of Contents
