Table of Contents
Advertisement
Operating the appliance
en
Change the programme
default settings
You can use or change the default
settings for this washing cycle.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Pressing and holding the button
Note:
automatically runs through the set
values to the end. Then press the button
once more and you can then change
the setting values again.
The settings are activated without
needing to be confirmed.
The settings are not saved after
switching off the washing machine.
Default programme settings
~ Page 32
Select additional programme
settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The button indicator lamps light up if a
setting is activated.
The settings are not saved after
switching off the washing machine.
Additional programme settings
~ Page 33
Start the programme
Press the Ü button. The indicator lamp
lights up and the programme starts.
The display panel shows the "Ready in"
time while the programme is running or
the programme length and the
programme progress symbols when the
36
washing programme has started.
Display panel ~ Page 25
Note:
Foam detection
If the o symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
activated additional rinse cycles to
remove the foam.
Add less detergent to the next washing
cycle with the same load.
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Child lock
(w 3 sec.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock.
To activate/deactivate, press and hold
the Ready in - and + buttons at the
same time for approx. three seconds.
The w symbol is appears in the
display panel.
w lights up: The childproof lock is
■
active.
w flashes briefly: The childproof
■
lock is active and the programme
selector was turned or a button was
pressed.
The childproof lock remains
Note:
active, even once the washing machine
has been switched off. Before selecting
the next programme, deactivate the
childproof lock.
Advertisement
Table of Contents
