R.V.R. Elettronica GPSRXNV-01 User Manual page 9

5.1.2 Preparation of the mains supply
WARNING: perform all the operations described in this section with the mains
supply disconnected.
The general fuse is accessible from the outside on the rear panel (see figure 6.2).
To check the integrity, or for substitution, remove the fuse holder with a screwdriver.
The fuse to be used is of type:
Mains Fuse: 1 A 5x20
Note: the switch (with lock position), for the connection of buffer battery, is kept
open (BATTERY OFF position) during transport. ). Check this condition and set
the switch to ON BATTERY position (see figure 6.2 - note [11]), after powering the
system.
5.1.3 Connections
Connect tge GPS ANTENNA input of GPSRXNV-01 (see figure 6.2 - note [11]) to
antenna receiver (figure 5.1).
Connect the 10MHz OUT - 1 output of GPSRXNV-01 (figure 6.1 - note [4]) to the
proper IN 10MHZ input equipped with apparatus of R.V.R. Elettronica like PTX-
LCD with SFN option (figure 5.1). If the equipment is of a different brand, identify
an equivalent input.
Connect the 1PPS OUT TTL - 1 output of GPSRXNV-01 (figure 6.1 - note [8])
to the proper REMOTE input equipped with apparatus of R.V.R. Elettronica like
PTX-LCD with SFN option (figure 5.1). If the equipment is of a different brand,
identify an equivalent input.
User Manual
Figure 5.1
Rev. 1.0- 16/11/07
GPSRXNV-01
5 / 14