Advertisement
Table of Contents
Operation Manual
Push Broadcast Spreader
50144
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Table of Contents
Related Manuals for XPOtool 50144
Summary of Contents for XPOtool 50144
- Page 1 Operation Manual Push Broadcast Spreader 50144 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
- Page 2 To allow for a smooth execution of your complaint or return, it is important to contact our customer service team before returning the goods. Returns Department WilTec Wildanger Technik GmbH Königsbenden 28 52249 Eschweiler E-mail: service@wiltec.info Tel: +49 2403 55592–0 Fax: +49 2403 55592–15 https://www.XPOtool.com Item 50144 Page 2 The Tool Experts 08 2022-1...
- Page 3 Do not use the spreader near other people or animals. • Only use the spreader at walking pace. • Do not use the spreader in rain or strong wind. Never leave it out in the rain. https://www.XPOtool.com Item 50144 Page 3 The Tool Experts 08 2022-1...
- Page 4 Steering link connector Lock washer Rear hopper support Hex nut M6 Right hopper support Screw M6×55 Left hopper support Release pin Split bushing Screw M6×40 Front bracket Cable lock nut Axle Slot https://www.XPOtool.com Item 50144 Page 4 The Tool Experts 08 2022-1...
- Page 5 Fasten the rear hopper supports (5) to the right hopper support (6) and the left hopper sup- port (7), using the M6×50 screw (14), small washer (16) and hexagon nut (18) as shown in the figure above. https://www.XPOtool.com Item 50144 Page 5 The Tool Experts 08 2022-1...
- Page 6 (11). Place the second wheel (2) on the right side of the axle (10) and se- cure it with the M6×50 screw (14), small washer (16) and hexagon nut (18). https://www.XPOtool.com Item 50144 Page 6 The Tool Experts 08 2022-1...
- Page 7 (9) with an M6×55 screw (19), a small flat washer (16), a lock washer (17) and a cable lock nut (22). Note! The control cable (1–1) comes pre-in- stalled on the hopper. https://www.XPOtool.com Item 50144 Page 7 The Tool Experts 08 2022-1...
- Page 8 (16) and a hex nut (18). Important: Reprinting, even in part, and any commercial use, including parts of the manual, only with the written consent of WilTec Wildanger Technik GmbH. https://www.XPOtool.com Item 50144 Page 8 The Tool Experts 08 2022-1...
Need help?
Do you have a question about the 50144 and is the answer not in the manual?
Questions and answers