Koolatron BITE SHIELD GUARDIAN MK14 Instructions Manual page 10

ASSEMBLY
Step 1: Support Pole assembly.
Assemble the bottom pole and the upper pole to form the Support Pole. Press the pins on
the side of the bottom pole and insert them into the holes in the upper pole. Make sure
that BOTH pins pop up through the holes in the upper pole.
Step 2: Support Pole connection to the Base.
Place the base on a flat surface. Insert the Support Pole with the slotted side down as
shown. Press in firmly. Ensure the pole has been inserted all the way down and turn base
sideways. Insert the locking pin through the hole at the bottom until it comes out on the
other side as shown. Then, insert the safety pin through the pin's hole as shown.
Step 3: Support Pole connection to the Main Unit
Attach the Main Unit to the top of the Support Pole as shown. Press the pins on the sides
of the Support Pole to insert it into the hole in the Main Unit. Make sure that one of the
pins pops up through the hole at the rear of the Main Unit.
Step 4: Battery Installation
Open the battery compartment by pressing the tab at the right side of the battery cover.
Let the battery cover hang from the unit as shown and insert four new "C" batteries
making sure that the positive and negative ends of the batteries are arranged as in the
picture. Close the battery pack by tilting the cover upwards and to the right until it snaps
in place.