Assigning Names To The Sources - JVC KD-DV5000 Instructions Manual

Assigning names to the sources

You can assign names to station frequencies,
CDs (both in this unit and in the CD changer),
and the external component.
After assigning a name, it will appears on the
display when you select the source.
Sources
Station frequencies
CDs*
External component Up to 8 characters
* You can assign a name only to conventional CDs.
1
Select a source you want to assign a
name to.
When you select a source, the
SRC
power automatically comes on.
2
While pressing DISP (D), press and
hold SEL (select) for more than
2 seconds.
DISP
D
Ex.: When you select "DISC" as the source
Maximum number of
characters
Up to 10 characters (up to
30 station frequencies
including both FM and
AM)
Up to 32 characters (up to
40 discs)
SEL
3
Select the character set you want
while the first character position is
flashing.
DISP
Each time you press the button,
D
the character set changes as
follows:
(A – Z: capital)
(0 – 9: numbers, and
4
Select a character.
ATT
5
Move the cursor to the next
(or previous) character position.
6
Repeat steps 3 to 5 until you finish
entering the name.
7
Finish the procedure while the last
selected character is flashing.
SEL
To erase entered characters
Insert spaces using the same procedure
described above.
Notes:
• When you try to assign a name to the 41st disc or to
the 31st station frequency, "Name Full" appears
and you cannot enter the text entry mode. In this
case, delete unwanted names before assignment.
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
(a – z: small)
symbols)
• About the available
characters, see page
66.
57