Advertisement
General description
The
200T
MKIII SERIES
LED display instruments. They are built into half DIN (96 mm x 48 mm) panel mounting
housings and operate on 12V-30Vdc power supplies, or from 110Vac/230Vac supply
using the supplied power adapter.
Two signal inputs are available, Input A and Input B. The two inputs share a common
input mode setting and sensitivity value (see page 6). If using only a single input signal
then this should be connected to Input A. The inputs can be set to operate in one of
three modes: standard sensitivity, high sensitivity and reed switch.
200T
Tachometers are available with factory fitted options which must be
MKIII SERIES
specified when ordering. These include alarms, analogue voltage and current outputs
and digital output. See the
Additionally,
Logitech
Tachometers to suit specialised applications. Many variations on the standard
software have been developed – please contact the Sales Office if this service is
required.
200T
MKIII SERIES
200T
-
Standard 200 MKIII Series Tachometer
200TL
-
200 MKIII Series Tachometer with Alarm Outputs
200TA
-
200 MKIII Series Tachometer with Analogue Voltage/Current Output
200TAL
-
200 MKIII Series Tachometer with Analogue Voltage/Current & Alarm Outputs
200TD
-
200 MKIII Series Tachometer with Digital Output
200TDL
-
200 MKIII Series Tachometer with Digital & Alarm Outputs
Tachometers are 4-decade seven segment high brightness red
Specification
will customise the programmed operating modes of these
Variants
section for more detail on these options.
3
Advertisement
