Table of Contents
Advertisement
1.4
How to service, English
Trouble shooting
Actions before dismantling the PDP
Test and adjustment of module(s)
Check the PDP for burn-in and pixel errors!
This check is very important when the PDP must be transported to a workshop.
Refer to PDP pixel test, page 1.9.
Before dismantling the PDP - disconnect the mains supply and wait minimum
1 minute for the electolytic capasitors to discharge.
Connect ESD-mat.
Preparations before adjustment
- Do not connect ESD-mat to PDP.
- Set the PDP to receive a picture, eg. generate internal picture. Refer to PDP pixel
test, page 1.9.
- Checking and adjusting voltage may be performed with a DC-voltmeter
(e.g. multi meter).
Ground is connected to the chassis in the PDP, if nothing else is specified.
Measuring- and adjustment point please refer to illustrations page 1.7.
Advertisement
Table of Contents
