Table of Contents
Advertisement
1.8
PDP self-check, English
PDP self-check
The self-check checks the status of the circuits connected to the IIC bus
1
LED
B
6
FD
FF
FE
When the PDP is fitted an aluminium front frame, point the NN remote control at
the hole in the left-hand front bottom side of the PDP. See 6.
By means of a thin tool press in the holes FD the FE and then FF on the NN remote
control.
For other operations point the NN remote in the same way.
-
Refer to illustrations for:
- Placement of black self-adhesive tape on the PDP.
- Placement of buttons on NN remote control.
-
Remove the black self-adhesive tape on the PDP. See 1.
-
Switch on the PDP.
-
Enter self-check mode.
Press button "B" on the PDP and at the same time button OFF TIMER on the
remote control. See 1 and 2.
The display will show ":-", while the self-check is performed.
-
Result of self-check. See 3.
"OK"
No fault
"- -"
Fault in or missing circuit
-
Exit self-check mode.
Press "Standby" on NN remote control and thereafter press Standby on Beo4.
-
Mount the black self-adhesive tape on the PDP.
2
+
_
VOL
+
Standby
3
ID
D
IC9702
IC9009
IC9019
IC9151
IC9305
R
IC9455
IC9605
IC9709
OFF TIMER
IIC1
IIC2
IIC3
J/
OK H21
OK H51
IC1001
DG
OK H61
IC3003
OK H63
OK H62
OK H64
IC3004
OK H53
IC3005
OK H65
- - -
OK H66
IC3006
OK H55
OK H56
Z
OK H52
OK H54
IC2401
Advertisement
Table of Contents
