Advertisement
ACRYLICARRIER
M A C A W
ASSEMBLY
INSTRUCTIONS
Getting started!
Read these notes first:
1.
Review these instructions thoroughly before attempting to
assembly the carrier. If you still require assi tance, please contact
Acrylic Habitats Customer Service.
a. Phone:
(984) 777-4811
b. Email:
cu sto merservi ce@acrylic h ab itats. co m
c. Online:
www.acrylich ab itats.co m
2.
Review All Parts:
If parts have been damaged or are missing,
please contact Acrylic Habitats Customer Service.
3.
Tools:
Phillips Screw Driver (not included). If using power tools,
please be careful not to overtighten any screws.
4.
Two-person assembly is recommended for best results.
5.
Protective Paper:
Please note the orientation stickers on the
protective paper. Test fit all pieces before removing the paper. If any
of the protective paper sticks to the acrylic, we recommend using
Goo Gone or an ammonia free glass cleaner to remove excess glue.
6.
Return Policy:
Returns are ONLY accepted in the original
packaging with the protective paper still intact.
7.
Visit
www. acrylich ab itats. co m
assembly videos!
8.
Please do not leave the carrier outside in direct sunlight. Acrylic
is an insulative material and may overheat.
s
for tutorials and
Advertisement
Table of Contents
Related Manuals for Phoenix Acrylic Habitats Acrylicarrier Macaw
Summary of Contents for Phoenix Acrylic Habitats Acrylicarrier Macaw
- Page 1 Getting started! Read these notes first: Review these instructions thoroughly before attempting to assembly the carrier. If you still require assi tance, please contact Acrylic Habitats Customer Service. ACRYLICARRIER a. Phone: (984) 777-4811 b. Email: cu sto merservi ce@acrylic h ab itats. co m c.
- Page 2 Parts List Door Knobs with screws (2) Bottom Phoenix Door Jam with screws (2) Side Door (2) Hex Nut Driver Stainless Steel Acrylic Habitats Corner Clips (12) Screws (24) Nuts (24) Feeder Cups (2) Front / Back (2) Perches (2) 11”...
- Page 3 Using the hex nut driver and a Philips screw driver, install six clips onto the back piece. The edge of the clips should be in line with the side edge of the back piece (Fig 1-1). Phoenix Phoenix Fig 2.1 Fig.
- Page 4 Step 3 Step 4 To assemble the top, bottom, and side pieces: To assemble the front piece: While not necessary, it may be helpful to have a second person assist in holding Using the hex nut driver and a Philips screw driver, install the last two clips onto the the pieces during this step.
- Page 5 Flip the unit up right so the bottom piece is now flat on the hard surface. THE CARRIER IS NOW FULLY ASSEMBLED AND READY FOR USE. CLEANING & CARE INSTRUCTIONS 1. When cleaning the carrier, use an ammonia free glass cleaner or mild dish soap.
Need help?
Do you have a question about the Acrylic Habitats Acrylicarrier Macaw and is the answer not in the manual?
Questions and answers