Advertisement
Quick Links
4
6
Thank you for purchasing a Japanese Myojin Style Torii Gate from SamsGazebos. Assembling it may take 45 minutes and an
hour to set with cement. Minimum two persons are recommended to assemble this item for your safety. Please work on a
clean level floor for the best result. Remove the wrapping material, prepare the tools and material, and lay out the parts before
assembly in order to save you time and effort. Each kit is custom built with pilot holes for your convenience. Wash hands after
handling. Handle with care; poles are round and heavy.
Tools / things you need:
◇ Cordless Screw Driver or Philips Screw Driver(+)
◇ Socket Wrench
◇ 2 Hammers
◇ Level
◇ Ladder
◇ Square
◇ Knife
◇ Pencil / Pen
◇ Measure Tape
◇ Shovel
◇ Minimum 4 bags of ready mix cement (Get extra bags of cement for large holes.)
◇ Wheelbarrow or container to mix cement
◇ Water
◇ Nitrile Gloves (included)
◇ 2 Strings (included)
◇ Hardware (two 1/2" x 8"lag bolts with washers, 4 large screws (2-1/2"), 22 small screws (1-5/8")(included)
SamsGazebos
Assembly Instructions & Installation Guide
5
3
2
1 HASHIRA
7
Japanese Myojin Style Torii Gate
○
R
T e mp o -
NUKI
r a r y
(2)
w o o d
Board
Bottom KASAGI
Top KASAGI
(3)
Made in the USA
Four KUSABI (6)
Two
GAKUZUKA (4)
Two Cement
Frames (7)
(5)
Advertisement
Related Manuals for SAMSGAZEBOS Japanese Myojin Style Torii Gate
Summary of Contents for SAMSGAZEBOS Japanese Myojin Style Torii Gate
- Page 1 Top KASAGI Thank you for purchasing a Japanese Myojin Style Torii Gate from SamsGazebos. Assembling it may take 45 minutes and an hour to set with cement. Minimum two persons are recommended to assemble this item for your safety. Please work on a clean level floor for the best result.
- Page 2 Minimum hole dimen- ATTENTION: sions : *Take time to check the 12” W x 12”L x 18” D LEVEL; it is very difficult to correct the Torii position later. 2. Place two wood blocks in the holes. Put an extra wood 1.
- Page 3 Bottom KASAGI GAKU NUKI 8. Alternatively, you can also do the step 7 with the Torii 7. Fasten the bottom KASAGI and the HASHIRA poles with on the ground. lag bolts from top. Bottom KASAGI GAKUZUKA NUKI *Alternatively, you can fasten the GAKUZUKA after step 20.
- Page 4 15. Gently hammer both KUSABI at the same time until a 16. Put the Top KASAGI. part of the KUSABI fills the hole; it will permanently lock the NUKI in place. Do the same for the other side of the NUKI. IMPORTANT: It is EXTREMLY important that you set each side of...
- Page 5 "more than 1 extra case of cancer in 100,000 people over a 70-year lifetime". Products and fasteners on both SamsGazebo.com and SamsGazebos.com can expose you to chemicals such as nickel, lead, chromium, or saw dust, which are known to the State of California to cause cancer and birth defects or other reproductive harm.
- Page 6 SamsGazebos ○ Japanese Myojin Style Torii Gate Care and Use info@samsgazebos.com 1(800) 376-7267 Torii CARE AND USE This product is made for a gate. This is not a structure to climb. Do not leave it without permanent installation. This product is treated with oil-based semi-transparent brown wood preservative. The color of the wood preservative is not permanent, will show trace of green from Copper, and turn to light brown ○...
- Page 7 SamsGazebos ○ Japanese Myojin Style Torii Gate Parts List info@samsgazebos.com 1(800) 376-7267 1 Top Kasagi 1 Bottom Kasagi 1 Nuki 4 Kusabi 2 Gakuzuka 2 Hashira 2 Cement Frames 1 Temporary wood & board 2 Strings Small wood blocks for leveling...