Table of Contents
Advertisement
16.13.1 Removal by Compulsory Loading
(Available when service mode is on even when the power cannot be turned off.)
1.
Press and hold down the "FF" and "EJECT" buttons at least three seconds then adjust the service number until
appears as "7".
2.
Press the "STOP" button to unload.
(Carefully check for tape slack)
16.13.2 Removal by Use of Battery to Rotate Loading Motor
1.
Unplug the power outlet, and remove the top panel and the front panel.
2.
Use a mechanism drive jig (or three AA-size batteries connected in series) in order to supply 4.5V and to rotate the
loading motor.
3.
Suspend the unloading operation right before completion. Rotate the S-reel board with a negative screwdriver
(small size) to remove tape slack.
Advertisement
Table of Contents
