Whirlpool R-92 Manual page 21

3. To reinstall the motor:
a) Remove the two screws from the hex
drive shaft coupling holder and remove
the coupling assembly.
Hex Drive Shaft Coupling
Screw
b) Install the hex drive shaft in the motor
as far as it will go.
c) Slide the new motor assembly back into
place in the freezer door and mount it
with the four screws you removed ear-
lier. Make sure that the top of the hex
drive shaft, spring, and pin are through
the hole in the ice container plate.
NOTE: On 2002, and later models, the
pin is not used.
Pin
Spring
Hex
Drive
Shaft
Screw
Coupling
Holder
d) Plug the harness connector into the mo-
tor. NOTE: The connector is designed
to fit only one way on the motor termi-
nals.
e) Position the motor housing cover so that
the raised center faces the motor, and
mount it in place with the two screws
you removed earlier.
f) Make sure that the spring and pin are
in the center hole of the hex drive shaft,
and that the bearing and seal are prop-
erly positioned on the coupling, as
shown.
g) Position the coupling assembly over the
spring-loaded pin, then push down on
the coupling and align it with the top of
the hex drive shaft. Secure the coupling
assembly with the two screws you re-
moved earlier.
Continued on the next page.
4-7
Coupling
Seal
Bushing
Hex Drive
Shaft
Push Down
On Coupling