Table of Contents
Advertisement
Available languages
Available languages
PSA1RIGKIT Installation
This is a step-by-step guide describing how to
assemble your PSA1 rig for fixed installations. A
Philips screwdriver and a C-wrench (or a right-
angle impact-driver) will be needed to complete
this assembly. The PSA1RIGKIT includes all the
hardware required to install the kit on one PSA1.
The PSA1FRAME1 and PSA1FRAME2 can fly a
maximum of 4 cabinets. Please follow the guide-
lines written in this document:
NOTE: The PSA1RIGKIT mounts directly
onto the handles of the PSA1 enclosure.
Steps 1-3 will not be necessary if the PSA1
being used was manufactured after February
2012. The newer enclosure's handles feature
threading and will allow the PSA1RIGKIT to
mount directly without removal.
NOTE: A torque of 125 inch/pounds is
recommended when tightening the hardware.
1. Removing Amp Module
Place the PSA1 on a solid flat surface such as the floor or a sturdy table. Remove the 14 screws along the
edges of the amplifier module. When lifting the module out of the cavity be cautious of the wire-harness attach-
ing the module to the speakers.
2. Disconnecting Amplifier Module
Disconnect the wire-harness connecting the amplifier module to the speakers. The connector is located close
the module itself. Place the amplifier module and mounting screws aside, in a safe and secure location.
ii
Advertisement
Table of Contents
