JVC GR-DVL167EG Instructions Manual page 56

56
EN
SYMPTOM
*
Time code does not appear.
(
Images on the LCD monitor
appear dark or whitish.
)
The rear of the LCD monitor
is hot.
q
The indicators and the
image colour on the LCD
monitor are not clear.
w
The LCD monitor or
viewfinder indications blink.
e
Coloured bright spots
appear all over the LCD
monitor or the viewfinder.
POSSIBLE CAUSES
• "TIME CODE" is set to "OFF" in the
Menu Screen.
• In places subject to low tempera-
ture, images become dark due to
the characteristics of the LCD
monitor. When this happens, the
displayed colours differ from those
that are actually recorded. This is
not a defect of the camcorder.
• When the LCD monitor's fluores-
cent light reaches the end of its
service life, images on the LCD
monitor become dark. Consult your
nearest JVC dealer.
• The light used to illuminate the LCD
monitor causes it to become hot.
• This may occur when the surface or
the edge of the LCD monitor is
pressed.
• Certain Fade/Wipe effects, certain
modes of Programme AE with
special effects, "DIS" and other
functions that cannot be used
together are selected at the same
time.
• The LCD monitor and the view-
finder are made with high-precision
technology. However, black spots
or bright spots of light (red, green
or blue) may appear constantly on
the LCD monitor or the viewfinder.
These spots are not recorded on
the tape. This is not due to any
defect of the unit. (Effective dots:
more than 99.99 %)
TROUBLESHOOTING
CORRECTIVE ACTION
• Set "TIME CODE" to "ON" in the
Menu Screen (
• Adjust the brightness and angle of
the LCD monitor (
• Close the LCD monitor to turn it off
or set the Power Switch to "OFF",
and let the unit cool down.
— — — —
• Re-read the sections covering
Fade/Wipe effects, Programme AE
with special effects and "DIS"
( pg. 24 – 27, 33).
— — — —
(cont.)
pg. 35, 36).
pg. 15, 16).