How To Self-Check And Initialize The Hdd & Dvd Recorder - Magnavox H2080MW8 Service Manual

HOW TO SELF-CHECK AND INITIALIZE THE HDD & DVD RECORDER
1. Turn on the HDD & DVD.
2. To put the HDD & DVD into the HDD mode, press [HDD] on the remote control unit.
3. To put the HDD & DVD into the self-check mode, after pressing [V.SKIP] button, press the [0], [7], and [9]
buttons on the remote control in that order within three seconds.
Fig. a appears on the screen and all LEDs light.
Table 1: Description of Fig. a
INDICATION
DVD CONNECT STATUS (*1)
HDD CONNECT STATUS (*2)
HDD POWER ON HOURS (*3)
BE Ver. (*4)
FE Ver. (*5)
Sub Micon Ver. (*6)
4. Upon the self-check completion, Fig. b appears on the screen.
" ******* " differs depending on the models.
SELF CHECK
*1
DVD CONNECT STATUS :
*2
HDD CONNECT STATUS :
*3
HDD POWER ON HOURS :
*4
BE Ver. :
*5
FE Ver. :
*6
Sub Micon Ver. :
Fig. a: Self-Check Mode Screen
Connecting Condition of DVD(F/E)
Connecting Condition of HDD
Value of HDD power on hours obtained from S.M.A.R.T. command. (If not obtainable,
value of HDD power on hours is "0".)
Value in parentheses is the factory setting value. (If no setting, the value is "0".)
B/E version
F/E version
Sub micro controller version
" ******* " differs depending on the models.
SELF CHECK
*7
DVD CONNECT STATUS :
*8
HDD CONNECT STATUS :
HDD POWER ON HOURS :
BE Ver. :
FE Ver. :
Sub Micon Ver. :
*9
HDD FORMAT :
*10
POWER OFF :
Fig. b: Screen of Finishing Self-Check Mode
HD4A*****H1E-****
R40_***_***
HD4***TTP
DESCRIPTION
OK
OK
120
HD4A*****H1E-****
R40_***_***
HD4***TTP
ENTER
POWER
1-7-1 E2H00INT