Recording; Basic Recording - JVC GR-AX527UM Instructions Manual

Compact vhs camcorder
Table of Contents

Advertisement

Available languages

Available languages

14
POWER
Start/Stop
The power indicator
Tape remaining time
indicator
120MIN
119MIN
1MIN (Blinking)
0MIN (Blinking)
*
MIN.....(Now calculating)
Tally lamp
NOTE:
LENS COVER
You should already have performed the procedures listed
SWITCH
below. If not, do so before continuing.
Power (
Tape Length/Recording Mode Setting (
Grip Adjustment (
LOAD A CASSETTE
1
Slide EJECT to open the cassette holder, then insert
the cassette with the label facing out. Press PUSH to
ensure the holder is closed and locked.
ENTER RECORD–STANDBY MODE
2
Slide the LENS COVER open/close switch to open
the lens cover, then set the power switch to
CAMERA.
•The power indicator lights and the camcorder
•The scene you're aimed at appears on the
START SHOOTING
3
Press the Recording Start/Stop button.
•The tally lamp lights while recording is in progress,
3MIN
STOP RECORDING
2MIN (Blinking)
4
Press the Recording Start/Stop button again to stop

recording.

•The camcorder re-enters the Record-Standby
NOTES:
A cassette holder can't be opened unless a power
supply is attached.
There may be a delay after you slide EJECT until the
holder opens. Do not use force.
The tape's remaining time is displayed in the
viewfinder as shown.
"TAPE END" appears when the tape reaches its end,
and the power goes off automatically if left in this
condition for 5 minutes. "TAPE END" also appears
when a cassette whose tape is already at its end is
loaded.
If the Record–Standby mode continues for 5 minutes,
the camcorder's power shuts off automatically. Set the
power switch to POWER OFF, and then back to
CAMERA to turn the camcorder on again.
If you're recording on a cassette from the middle, use
the RETAKE function (
last recording so you don't erase any of it.
The LENS COVER warning blinks for about 5 seconds
when the camcorder is turned on, whether the cover is
open or closed.
RECORDING
pg. 8)
pg. 12)
enters the Record–Standby Mode.
viewfinder screen, with the word "PAUSE"
superimposed upon it.
and "
REC
" appears in the viewfinder.
mode.
pg. 15) to find the end of the

Basic Recording

pg. 11)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents