JVC GR-AX210EA Instructions Manual page 23

Animation
Give stationary scenes or objects an illusion of
movement. This function allows you to shoot a
series of pictures, each slightly different, of the same
object for a brief period of time.
NOTE:
You need the optional RM-V20U remote control
unit to perform the following procedure.
ENGAGE RECORD–STANDBY
MODE
1
Make sure the lens cover is open, then set the
power switch to CAMERA.
SET RECORDING TIME
2
Press REC TIME on the remote control. Three
choices are available, and they appear in the
following order (each time REC TIME is
pressed): 1/4S (one-fourth of a second), 1/2S
(one-half of a second) and 1S (one full second).
Press again to release the Animation mode.
START RECORDING
3
Press Recording Start/Stop after focusing on the
subject. The recording stops automatically after
the selected period of time.
ASSEMBLE SERIES OF
PICTURES
4
Repeat steps 2 and 3 for the desired number of
pictures.
CHECK YOUR WORK
5
Play back the series of pictures to see if the
results were satisfactory.
RELEASE ANIMATION MODE
6
Press REC TIME until "
viewfinder.
NOTES:
For best results, make sure the camcorder is
secured when shooting.
If the PROGRAM AE dial is set to Self-Timer
mode, Animation is cancelled and Self-Timer
mode is engaged with 15S selected.
Fade-in/out cannot be performed during
Animation shooting.
Untitled-2
Time-Lapse
You can record sequentially at preset time spans.
Leaving the camcorder aimed at a specific subject,
you can record subtle changes over an extended
period of time.
1
2
3
4
5
" disappears from the
NOTES:
23
ENGAGE RECORD–STANDBY
MODE
Make sure the lens cover is open, then set the
power switch to CAMERA.
SET RECORDING TIME
Press REC TIME on the remote control. There
are three choices available, and they appear in
the following order (each time REC TIME is
pressed): 1/4S, 1/2S and 1S. Press again to
reset.
SET INTERVAL BETWEEN
RECORDINGS
Press INTERVAL on the remote control. There
are four choices available, and they appear in
the following order (each time INTERVAL is
pressed): 15S, 30S, 1MIN, and 5MIN. Press
again to reset.
START TIME-LAPSE
RECORDING
Press Recording Start/Stop. Recording and
intervals alternate automatically.
RELEASE TIME-LAPSE MODE
To release when the tally lamp is not blinking,
press INTERVAL and REC TIME repeatedly
until " " and " " disappear. To release
when the tally lamp is blinking, press
Recording Start/Stop to stop the blinking, then
press INTERVAL and REC TIME repeatedly
until " " and " " disappear.
Fade-in/out cannot be performed during
Time-Lapse shooting.
For best results, keep the camcorder secured
while shooting.
If, during steps 2 and 3, the PROGRAM AE dial is
set to the Self-Timer mode, the Self-Timer mode is
engaged with 15S selected.
96.10.8, 2:18 PM
23