System Connection - JBL SCS SAT 300 Owner's Manual

SYSTEM CONNECTION

Connect each speaker to
the corresponding speaker
terminals on your receiver
or amplifier.
If you are using a subwoofer,
follow the directions in that
owner's guide to connect and
configure it.
Left Front
–
Left Surround
– +
6
Configure your receiver or
processor to reflect the cor-
rect number of speakers in
your system. If you have
added one SCSSAT300
speaker to a 5.1-channel sys-
tem, reconfigure it as
a 6.1 system. If you have
added two SCSSAT300
speakers to a 5.1-channel
system, reconfigure it as
a 7.1 system.
+
Left
Front
– +
Left Surround Back
Surround
– + –
–
Surround Back
Center
– +
Subwoofer
LFE In
Receiver
Subwoofer
Out
– +
Center
Surround Back
Left Right
+ –
+ –
Surround Back
Left Right
The front left, front right, cen-
ter and rear speakers should
all be set to "Small." If your
receiver allows you to set the
crossover frequency
between the subwoofer and
the main speakers, select
100Hz or the setting that is the
closest frequency below it.
Right Front
– +
Right
Front
– +
Right
Surround
+
– +
Right Surround
+
– +