LG STUDIOWORKS 77M Service Manual page 26

1. TILT/SWIVEL REMOVAL
1) Set the monitor face down.
2) Pressing the latch (a), carefully remove the
Tilt/Swivel by pulling it upward.
2. BACK COVER REMOVAL
1) Remove four screws (a) from the Back Cover.
2) Slide the Back Cover away from the Front
Cabinet of the monitor.
(a)
DISASSEMBLY
3. TOTAL CHASSIS ASSEMBLY REMOVAL
1) Disconnect P901 (Degaussing pin), P701
2) Remove two screws (a) from the Main Bracket
(a)
4. CRT BOARD ASSEMBLY REMOVAL
1) Remove three pins (a).
2) Remove the CRT ground connector (b).
3) Carefully separate the CRT Board Assembly
4) Discharge the remaining static electricity by
5) Disconnect the Anode Cap from the CRT.
(H-DY pin), and P601(V-DY pin).
to separate it from the Front Cabinet.
(a)
from the CRT neck.
shorting between the Anode Cap and the CRT
ground.
Anode Cap
(a)
(a)
(a)
(b)