Programming; Using Programming Bar Codes; Configuring Other Settings - Datalogic DSM0400 Quick Reference Manual

Fixed mount area imager bar code reader

Hide thumbs Also See for DSM0400:

Table of Contents

DSM0400 Fixed Mount Area Imager Bar Code Reader

Programming

The reader is factory-configured with a set of standard default fea-

tures. After scanning the interface bar code from the Interfaces sec-

tion, you can select other options and customize your reader through

use of the programming bar codes available in the DSM0400 Product

Reference Guide (PRG).

Programming can also be performed using the protocol "Decoded

Engine Serial Protocol" (DESP) or using Datalogic Aladdin™ Configura-

tion application, which is downloadable from the Datalogic website

listed on the back cover of this manual. This multi-platform utility

programs allow device configuration using a PC. It communicates

with the device using a serial or USB cable and can also create config-

uration bar codes to print.

This manual contains bar codes which allow you to reconfigure your

reader. Some programming bar code labels, like

Reset Default Set-

tings on page

13, require only the scan of that single label to enact

the change.

Other bar codes require the reader to be placed in Programming

Mode prior to scanning them. Scan an ENTER/EXIT bar code once to

enter Programming Mode; scan the desired parameter settings; scan

the ENTER/EXIT bar code again to accept your changes, which exits

Programming Mode and returns the reader to normal operation.

Additional programming bar codes are available in the PRG to allow

for customization of programmable features. If your installation

requires different programming than the standard factory default

settings, please refer to the PRG.

DSM0400

Table of Contents