Table of Contents
Advertisement
FIG. 3
ATTACHING POWER CABLE TO CARRYING HANDLE (FIG. 3)
1.
Use the handle locking knob (13) to attach the power cable connector (14) to the carrying
handle (1) as shown in Fig. 3.
FIG. 4
ATTACHING STAND TO TRIPOD (FIG. 4)
1.
Before attaching the stand to tripod, be sure to grasp handle to secure the stand in place.
2.
Place the work light assembly on the top of the tripod. The cross bar at the bottom of the
stand needs to be sitting in the bracket (F).
3.
Flip up the two small steel buckles (G) over the base of the stand.
4.
Lift the large toggle latch (H), securing both small buckles, and then snap it downward to
ensure the buckles are locked in place.
5.
Remove the work light assembly from the bracket in the opposite way.
8
1
13
14
G
F
H
Advertisement
Table of Contents
