Table of Contents
Advertisement
FIG. 2A
2
9
7
F
E
D
A
C
B
ADJUSTING THE TRIPOD (FIG. 2A)
1.
Loosen the tripod locking knob (C).
2.
Push down the leg connector (A) until the legs (B) are fully extended. Firmly tighten the
tripod locking knob (C).
3.
Adjust the height of the tripod by loosening the twist collars (D) and raising the center poles
(E) of tripod. Firmly tighten the twist collars when the tripod reaches the desired height.
NOTE: The maximum height of this tripod is 58.5".
ATTACHING CARRYING HANDLE TO STAND (FIG. 2A-2B)
1.
Place the carrying handle (1) vertically on the stand (7).
2.
Use two bolts (10), spring washers (11), and flat washers (12) to secure the carrying
handle on the stand as shown in Fig. 2A and Fig. 2B.
ATTACHING WORK LIGHT HEADS TO STAND (FIG. 2A-2B)
1.
Place the stand (7) on a flat surface.
2.
Use two six-point locking knobs (9), spring washers (11), and flat washers (12) to secure
both work light heads (2) on the sides of the stand as show in Fig 2A and Fig. 2B.
10
11
12
ASSEMBLY
1
6
FIG. 2B
7
Advertisement
Table of Contents
