Page 1
® Explorer Balance Display Tower Mount Kit Installation Instructions...
Page 3
Explorer ® Display Tower Mount Kit 1. INTRODUCTION Please read this manual completely before installation and operation. CAUTION: READ ALL SAFETY WARNINGS BEFORE INSTALLING, MAKING CONNECTIONS, OR SERVICING. FAILURE TO COMPLY WITH THESE WARNINGS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE.
Page 4
Explorer ® Display Tower Mount Kit 2.2 Installation procedure Follow the steps below. Refer to the Figures when performing these steps. Make sure Balance is unplugged (turned OFF). Detach the Display: press buttons on both sides to disconnect. Then pull Display away from base.
Page 5
Explorer ® Display Tower Mount Kit Release the clip that secures the Display Communication Cable: press out on both sides, as shown. Unplug the Display Communication Cable. Un-spool the Display Communication Cable from the base. Tower mount M5 screws Attach Tower to the Base using the four M5 screws and wrench (supplied).
Page 6
Explorer ® Display Tower Mount Kit Pull the Display Communication Cable through the top of the tower. Position the Display above the Tower Platform. Insert the posts in the receptacles in the Display Base. Slide the Display forward as shown, to seat it in the Tower platform.
Page 7
Explorer ® Display Tower Mount Kit Insert the cable plug with the security clip open, then press the security clip into position to secure the cable. Route the cable through a groove in either side of the Display, or from the rear of the Display, as preferred.
Need help?
Do you have a question about the Explorer and is the answer not in the manual?
Questions and answers