Advertisement
3.2
USING THE WRENCH
WARNING! Ensure you read, understand and apply safety instructions before use.
p
3.2.1
Use only impact sockets which are specifically designed for use with an impact wrench. The use of normal chrome vanadium or
p
carbon steel sockets is dangerous since these are more brittle and are liable to shatter.
3.2.2
Fit the socket to the wrench by snapping it onto the square drive (fig 1.3).
3.2.3
Ensure that the forward/reverse control (fig.1.4) is in the central (locked) position.
3.2.4
Fit the battery pack to the wrench. The battery pack slides onto the wrench either from the front or the rear, depending on personal
preference with regards to tool balance.
3.2.5
Select the required direction of rotation. To change direction, push forward/reverse control (fig.1.4) to the left or right. Familiarise yourself
with this operation before use. DO NOT attempt to change the direction of rotation whilst trigger (fig. 1.5) is depressed.
When the wrench is not in use, use the same switch to lock off the trigger by placing the switch in the middle position.
3.2.6
Squeeze the trigger to operate the wrench. The harder the trigger is squeezed the faster the wrench drive rotates.
3.2.7
When tightening, release the trigger as soon as the impact sound is heard. Take care not to over-torque small fixings.
Note: On critical fixings always check the torque with a torque wrench according to the product or vehicle manufacturer’s guidelines.
4. MAINTENANCE
4.1
CLEANING
Keep the outer case of the wrench clean and free from grease. DO NOT wash with water or use solvents or abrasives. Use a damp cloth.
For any other service or maintenance, contact your authorised service agent.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts
without prior notice. IMPORTANT: No liability is accepted for incorrect use of this equipment. WARRANTY: Guarantee is 12 months from
purchase date, proof of which will be required for any claim. INFORMATION: For a copy of our latest catalogue and promotions call us on
01284 757525 and leave your full name and address, including postcode.
Declaration of Conformity
IMPACT WRENCH & BATTERY CHARGER
Models: CP1502.V2, CP3002/26
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
01284 757500
We, the sole importer into the UK, declare that the product listed here is in conformity with the following standards and directives.
The construction file for this product is held by the Manufacturer and may be inspected, by a
national authority, upon request to Jack Sealey Ltd.
Signed by Mark Sweetman
Sole UK Distributor, Sealey Group, Bury St. Edmunds, Suffolk.
01284 703534
22nd February 2005
www.sealey.co.uk
Web
For Jack Sealey Ltd.
Sole importer into the UK
of Sealey Power Tools.
sales@sealey.co.uk
email
CP1502.V2 - 1 - 220205
Advertisement
