Page 1
COMPLETE RESTROOM RESTORATION 17 GALLON PROFESSIONAL RESTROOM CLEANER OWNER’S/OPERATOR’S MANUAL PROUDLY DESIGNED AND MANUFACTURED BY WWW.EDIC-USA.COM...
Page 2
• Do not use water in excess of 130°F (54°C) in the solution EDIC’s Liability ceases when the carrier picks up the ship- tank ment. However, our customer service staff will be happy to •...
GROUNDING INSTRUCTIONS: This piece of equipment must be grounded. Should an electrical malfunction occur, grounding provides a path of least resistance for electrical current- reducing the risk of electric shock. This piece of equipment is furnished with a cord that has a grounding conductor and ground- ing plug.
Page 4
1. Handle- Used to maneuver and position the CR2 and no chemical by turning to left or right as marked 2. Recovery tank lid- Allows access to recovery tank 12. Male twist lock pigtail- Connects to 50 ft cord and creates a seal to ensure suction 13.
Page 5
Assembling the accessory racks: Installing an accessory heater: The CR2 is shipped with the accessory racks and hard- If a 600HR Heat “n” Run heater system has been pur- ware in the solution tank. When you receive your CR2, chased for the CR2, use the following illustration to it is necessary to secure the racks to the body.
Page 6
1.25oz/Gal two mounting brackets on the rear of the machine. Turquoise 2.00oz/Gal (19 on page 4) Pink 3.00oz/Gal 2. Fill the solution tank of your CR2 with sufficient Brown 4.00oz/Gal water for the task at hand White 5.00oz/Gal 3. Connect your heater’s in hose (#2 on page 5) to #16...
Flush chemical lines • Check and clean vacuum filter The CR2 has a hose barb (13 on page 4) fitted to the vac- uum motor’s exhaust. By attaching a hose to this fitting, Weekly: the energy from the exhaust is redirected and allows the •...