JBL Project Everest DD66000 User Manual page 35

• In case shorting straps are used, make sure the conductors and sleeves of the
straps are firmly fastened at the terminals.
• For the best connection, a cable termination with either a spade- or banana-
type connector is recommended.
As mentioned earlier, the Project Everest DD66000 loudspeakers may be
connected to the amplifier(s) by one of three methods: passive, bi-wire and bi-
amp. Each method described above has its own advantages, and the Project
Everest DD66000 loudspeaker system will deliver superb performance with
any method.
Final Checklist:
• Connect and plug in all other system electronics.
• Check all connections. In case of bi-amping or bi-wiring, make sure both
shorting straps are removed.
• Make sure the system orientation and HF/LF drive switching in the control
panel are correctly set.
The system is now ready for use. The Project Everest DD66000 loudspeaker
system is fully functional as soon as it is set up. There may be subtle tonal
changes in bass output over the first week to 10 days of operation. These are
caused as the movement of the low-frequency drivers becomes more fluid and
the parts settle in. This process is completely normal and natural with
transducers of this caliber. Even during this initial period, there is no restriction
on the amount of amplification that may be applied. Enjoy!
Project Everest DD66000
35