Advertisement
STEP 5
With the adjustable feet installed, go back
and tighten up all the bolts of the rack. When
everything is tightened, you may now stand
the rack up. We recommend that 2 people are
used to stand the rack up. NOTE: Racks
using more than one base will have
compartments like the one shown below
STEP 6
Next install the helmet/ boot shelves (HBS-18,
20 or 24). Determine your desired height for the
shelves. To install, tilt the shelf at an upward
angle and slide the downward facing hooks
through the diagonal wires of the divider panel.
Then lower the shelf in place so that hooks
from both sides of the shelf are level.
STEP 7
Once the helmet shelves are in place you can
install the hanging pole in each compartment.
Using two hanging wire grommets, attached
one to each end of a hanging rod and hang it
from the underside of the helmet shelf. Insert
the end caps to each end of the hanging pole.
5
Advertisement
