Related Manuals for Ready Rack MSS
Summary of Contents for Ready Rack MSS
- Page 1 Mobile Ready Rack WASH • DRY • STORE • PROTECT ITEM#:MSS ASSEMBLY INSTRUCTIONS & PARTS LIST 2021-1 (800) 991-9120 • SALES@GROVES.COM • WWW.READYRACK.COM...
-
Page 2: Hardware Needed
PARTS ALL PARTS SHOWN BELOW: Rubber Mallet - Divider panel Shelving - Divider panel top - Shelving - Posts - Shelf grippers Self grippers - Split sleeves Divider panel Divider panel top - Back ledge - Hanging pole - Label holder Hanging pole - Hanging grommet - Stem casters... - Page 3 STEP 2 STEP 3 STEP 1 Attach casters to the open end of Next you will need to attach your split You can now run your post through the 74” tall posts (four posts per sleeves to the bottom of the posts the holes on the bottom shelf.
- Page 4 STEP 4 STEP 5 STEP 6 Once finished, you can stand up Measure 64 inches from the top of the You are now ready to install your your rack and make sure the shelf is bottom shelf to the top of the next split divider panel.
- Page 5 STEP 7 STEP 8 STEP 9 Take your hanging pole and slide it Once you’re sure your divider panel is Add two shelf grippers to the top and through the top middle section of the straight, you can now put the top on, bottom, as shown.
- Page 6 STEP 10 STEP 11 Attach the 4 inch back ledges to both The last step is putting on the label shelf levels by sliding the wire bottoms holders and bunker pant hooks over the quarter inch truss wire.
- Page 7 Please visit readyrack.com/guides to find more information and other assembly instruction guides. "WE TAKE CARE OF THE GEAR THAT TAKES CARE OF YOU" GROVES INCORPORATED 818 TRAKK LN, WOODSTOCK, IL 60098 800-991-2120 • SALES@GROVES.COM WWW.READYRACK.COM...