Table of Contents
Advertisement
a. Charging
HYUNDAI range battery and charger not sold together with this tool. Battery has not been fully
charged at the factory.
Before using it for the first time, charge the battery for 60min to 130min. Insert the charger plug
into the charging socket and plug the charger into a 230V/50Hz electrical outlet. Detailed
information please read carefully the manual for battery and charger.
Charge status
To display the amount of charge left in the battery, press the charge level indicator button,
Fig.2.
b. ATTACHING THE BLADE
A 6 1/2 in. blade is the maximum blade capacity of the saw. Never use a blade that is too thick
to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in
contact with the blade guard, while thicker blades will prevent blade screw from securing the
blade on the spindle. Either of these situations could result in a serious accident.
Always remove the battery before installing blades.
The blade is extremely sharp and care must be observed when handling. Caution must be
observed as the blade guard is spring loaded and if released may cause an injury. Rotate the
blade guard into the fully open position and secure it in this position using a screwdriver or
piece of wood.
Depress the spindle lock button Fig.3.
CAUTION: To prevent damage to the spindle or spindle lock, always allow motor to come to a
complete stop before engaging spindle lock.
Advertisement
Table of Contents
