Removing The Blade - Hyundai HSC20V Instruction Manual

Remove the blade screw by turning it clockwise with the hex key, while keeping the spindle
lock button depressed Fig.4.
Remove the blade washer noting which way round it is fitted.
Fit the saw blade inside the lower blade guard and onto the spindle ensuring that the direction
of rotation arrow on the blade corresponds with the direction of rotation arrow on the fixed
guard arrow Fig.5.
NOTE: The saw teeth point upward at the front of the saw.
Replace the blade washer. Depress the spindle lock button, and then replace the blade screw.
Tighten the blade screw securely by turning it clockwise.
Note： Check the tightness of the blade securing bolt before, during and after each use.
Take up the tension on blade guard and remove the piece of wood or screwdriver that is
holding it in the open position. Slowly release the guard so that it covers the blade. Check the
operation of the blade guard making sure that it operates correctly. The operation is complete
and your machine is ready for use.
c. REMOVING THE BLADE
Remove the battery pack from the saw.
Depress the spindle lock button, and remove the blade screw by turning it clockwise.
Remove the outer blade washer.
Remove the blade.
d. ATTACHING THE PARALLEL GUIDE
Before attaching the parallel guide please ensure the battery is removed from the machine.
Place the parallel guide through the holes in the base, Fig-6.
Adjust the parallel guide to the width needed and then tighten the parallel guide locking knob
making sure the guide is secure.
Note: Use the parallel guide provided when making long or wide rip cuts with the saw.
e. Installing the battery pack
Warning! Always remove battery pack from your tool when you are assembling parts, making
adjustments, cleaning, carrying, transporting or when it is not in use. Removing the battery
pack will prevent accidental starting that could cause serious personal injury.
NOTE: To avoid serious personal injury, always remove the battery pack and keep hand clear
of the lock out button when carrying or transporting the tool.
Slide battery pack into the pole saw base, Fig 7. Make sure that the battery pack snaps into
place and that the battery is secured in the tool before beginning operation. Improper
installation of the battery pack can cause damage to internal components.
f. Removing battery pack
Locate the battery release catch on the top of the battery and press downwards, Fig 8. Whilst
holding down the battery release catch slide the battery pack away from the tool.