Advertisement
NOTE: Component photos are not to scale
Pump Kit Parts List
PK120-A pump (1)
#10 compression stopper (1)
Approx. 6" length of 1/2" black non-kink tubing (1)
4mm Allen wrench (1)
Hose clamps (1) Note – Hose clamp to be used as
flow restrictor if necessary
Wedges (2)
Adhesive Dots (4)
FT- 161 M-Series Platia Fountain
(4 pieces)
COMPONENTS AND PARTS LIST
FT-161A
6"dia x 2.5" H
3 Lbs
FT-161B
11"dia x 3.25" H
13 Lbs
FT-161C
6.75"dia x 3.25" H
4 Lbs
FT-161D
15.25"dia x 4.75" H
26 Lbs
Fountain holds approximately
2 ½ gallon(s) of water
No cover available for
Tools you will need
Level
4mm Allen wrench (included)
Revised May 24, 2012
this fountain
Advertisement
Table of Contents
Related Manuals for Campania International FT-161
Summary of Contents for Campania International FT-161
- Page 1 FT- 161 M-Series Platia Fountain (4 pieces) Revised May 24, 2012 COMPONENTS AND PARTS LIST FT-161A 6”dia x 2.5” H 3 Lbs FT-161B 11”dia x 3.25” H 13 Lbs FT-161C 6.75”dia x 3.25” H 4 Lbs FT-161D 15.25”dia x 4.75” H 26 Lbs Fountain holds approximately 2 ½...
- Page 2 FT- 161 M-Series Platia Fountain (4 pieces) Revised May 24, 2012 ASSEMBLY INSTRUCTIONS 1. Make sure you are assembling your fountain on a level surface. 2. This fountain will need to be installed on a surface capable of holding a minimum of 67 pounds in a ¼ square foot area.
Need help?
Do you have a question about the FT-161 and is the answer not in the manual?
Questions and answers