Energy Saving Tips; Troubleshooting Guide; Wiring Diagram - Muskoka MWC30P Manual

Energy saving tips

• The Wine Cooler should be located in the coolest area of the room, away from heat producing appliances,
and out of direct sunlight.
• Overloading the Wine Cooler forces the compressor to run longer.
CARE AND MAINTENANCE
You can solve many common Wine Cooler problems easily, saving you the cost of a possible service call. Try the suggestions
below to see if you can solve the problem before calling the service center.

TROUBLESHOOTING GUIDE

Problem
Wine cooler does not operate.
Turns on and off frequently.
Vibrations
The Wine Cooler seems to make too much noise.
The door will not close properly.

WIRING DIAGRAM

Possible Cause
Not Plugged in.
The circuit breaker tripped or a blown fuse.
The door temperature is hotter than normal.
The door is opened too often.
The door is not closed completely.
The temperature is not set correctly.
The door gasket does not seal properly.
The Wine Cooler does not have the correct clearances.
Check to assure that the Wine Cooler is level.
The rattling sound may come from the flow of the refrigerant,
which is normal.
As each cycle ends, you may hear gurgling sounds caused
by the flow of refrigerant in your Wine Cooler.
Contraction and expansion of the inside walls may cause
popping and cracking noises.
The Wine Cooler is not level.
The Wine Cooler is not level.
The gasket is dirty.
The shelves are out of position.
THERMOSTAT
LAMP
PLUG
SWITCH
MOTOR
PROTECTOR
STARTER
COMPRESSOR
7